Your City HallOnline ServicesBylaw EnforcementDepartmentsMayor and CouncilEmployment 2022 General ElectionEmergencies
Sandbags and Spring Flooding
SANDBAGS AND SPRING FLOODINGThere are occasions during the Okanagan year when spring flooding may pose a threat to properties adjacent to creeks and lakes. Learning how to use sandbags to protect your property against flooding can save you money, hassle and time.
The District of Peachland has sandbags available for residents who may be affected by rising creek waters. The District may make a sand pile available to residents for filling sandbags.
There are other options available as well when looking for suitable sandbags. One is to use untreated burlap bags, generally used for animal feed, rice or grains. You may be able to purchase these at your local hardware or farm supply store or you can find several sources online. Another option is the new synthesized woven plastic bags, made especially for sandbagging. These have the benefit of lasting longer if cared for properly. Again, there are several good sources of this type of sandbag online. Although garbage bags seem like a good choice for sandbags, their exterior makes them too difficult to handle and too slippery to stack properly.
Once the danger of flooding has presented itself, it's time to fill the sandbags. Note that they should not be filled and stockpiled for future use as the soil or sand that fills them will degrade the bags quickly.
It takes two people to effectively fill the sandbags. The material you use can be soil, sand or small gravel (only if no other materials are available). Fine sand may sift through natural burlap bags so is best used in the plastic ones. One person will kneel down near the pile of fill and hold the bag open and stable. The other person will shovel the fill material into the sandbags until they are about half full. For temporary sandbag placement, the sandbags should not be tied off but the open flap should be flattened and folded underneath the full bag.
The bags could weigh anywhere from 25 to 35 pounds when full so proper attention should be paid so as to avoid injury.
Once the sandbags are full, they can be stacked where needed. The ground underneath where the sandbags will be placed should be flat and clear of debris such as twigs and leaves.
Before final placement of the sandbags, determine from which direction the water will come and where you want to divert it to. Water building up on the other side of the sandbag wall will need to flow somewhere else so make sure you know where you want it to go. For example, diverting flood water from your property and directing it at the neighbor's property is not a good idea for many reasons, including the fact that it could open you up to lawsuits.
Once the nature of the diversion has been established, you can start building the sandbag wall. The sandbags will act much like bricks and are placed in a similar fashion. The first row is laid with the sandbags nestled tight up against each other. The second row is laid with each bag being offset a half-bag's width from the first row. The third row goes on top offset against the second row of sandbags. After laying each row, push down on each sandbag to ensure that it provides the best water block and nestles into the adjacent sandbags. For sandbag walls in excess of three feet, it will be necessary to double the wall and use two rows of sandbags for each course otherwise the pressure from the rising water could topple the entire structure.
After The Threat of Flooding Has Passed
When the threat of flooding has passed, dismantle the sandbag wall and empty the bags of their material as quickly as possible. Soil or sand left in sandbags can cause the bags to break down quickly. After each sandbag has been dumped, let dry in the sun until there is absolutely no moisture left in the bags, then store in a cool dry place until the sandbags are needed next time.
Okanagan Flood Story Portal
The Okanagan Flood Story portal contains flood maps and information on flood risk reduction and preparation. The portal was created by the Okanagan Basin Water Board with the Regional District of Central Okanagan and other regional partners.